 Hitachi H48C Tri-Axis Accelerometer Module
The Hitachi H48C Tri-Axis Accelerometer is an integrated module that can sense gravitational (g) force of ±3g on three axes (X, Y, and Z). The module contains an onboard regulator to provide 3.3-volt power to the H48C, analog signal conditioning, and an MCP3204 (four channel, 12-bit) analog-to-digital converter to read the H48C voltage outputs. All components are mounted on a 0.7 by 0.8 inch module. Acquiring measurements from the module is simplified through a synchronous serial interface. With the BASIC Stamp® series, for example, this is easily handled with the SHIFTOUT and SHIFTIN commands.
We do not recommend using this module with a breadboard. The design has fairly short pins with components on both the top and bottom of the module. A permanent mounting location on a through-hole board like the Parallax Super Carrier Board is the only mounting solution we support for the Hitachi H48C Tri-Axis Accelerometer.
Features:
- Measure ±3 g on any axis
- Uses MEMS (Micro Electro-Mechanical System) technology, with compensation for calibration-free use
- Onboard regulator and high-resolution ADC for simple connection to microcontroller host - compatible with BASIC Stamp 2 series SHIFTOUT and SHIFTIN commands
- Free-fall output indicates simultaneous 0g an all axes
- Small, breadboard-friendly package: 0.7" x 0.8" (17.8 mm x 20.3 mm)
- Wide operational range: -25° to 75° C
 Manual de esquematicas. - 1.0 MB
Principios de la deteccion de caidas. - 0.3 MB
 Ejemplo de Codigo BS2 - 0.1 MB
Codigo: PACC00028026
|
Accelerometer Module
